Sony BRAVIA 4-256-733-F2(1), Operating Instructions Manual

Page: 42 / 72

42
GB
Connecting with an
Ethernet Cable
You can connect the built-in PlayStation
™
2 to
a network using an Ethernet cable connected
to the NETWORK connector on the rear. You
can connect to a 100 Base-TX or 10 Base-T
network. Refer to the instructions supplied
with the network device for details.
Network line:
This will vary depending on
the type of broadband service in your home.
Network equipment:
The type of
equipment used will also vary depending on
the type of service.
z
• When connecting the built-in PlayStation
™
2 and a
PC to the network, a network device such as a
router or a hub may be required. Refer to the
instructions supplied with the network device for
details.
• For more information on network setup, see
“About Advanced Operations of the
PlayStation
™
2” (page 32).
1
Connect the Ethernet cable to the
NETWORK connector on the rear.
2
Connect the Ethernet cable to the network
device.
~
• Do not plug the AC power cord (mains lead) for
the built-in PlayStation
™
2 into the electrical outlet
until you have made all other connections.
• Do not connect Ethernet cables or telephone cords
of the following types to the network connector;
too much electrical current may pass through the
connector, causing a malfunction, excessive heat
or fire in the connector:
– Standard residential telephone lines
– Ethernet cables not appropriate for use with a
10Base-T/100Base-TX network
– Any ISDN (digital) compatible phone or data
line
– PBX phone lines
– Other unknown types of telephone lines
Basic Network Setup
N etwork line
N etwork equipment Ethernet cable
(not supplied)
Broadband modem,
router etc.
PC
Connecting the Built-in
PlayStation
™
2
DSL Modem/Cable Modem
Internet
Router
Built-in PlayStation
™
2
N etwork cable (not supplied)
To network devices
N etwork cable (not supplied)