Sony BRAVIA 4-127-735-11(1), Operating Instructions Manual

Page: 28 / 44

28
GB
Sound Offset Sets an independent volume level to each equipment connected to the TV.
Manual Programme
Preset
(Only in analogue
mode)
Changes the available analogue channel setting.
Press
F
/
f
to select the programme number you want to modify. Then, press .
System
Presets programme channels manually.
1
Press
F
/
f
to select “System”, then press .
2 Press
F
/
f
to select one of the following TV broadcast systems, then
press
G
.
B/G: For western European countries/regions
I: For the United Kingdom
D/K: For eastern European countries/regions
L: For France
~
• Depending on the country/region selected for “Country” (page 7), this option may not be
available.
Channel
1
Press
F
/
f
to select “Channel”, then press .
2
Press
F
/
f
to select “S” (for cable channels) or “C” (for terrestrial
channels), then press
g
.
3
Tune the channels as follows:
If you do not know the channel number (frequency)
Press F / f to search for the next available channel. When a channel has been found,
the search will stop. To continue searching, press F / f .
If you know the channel number (frequency)
Press the number buttons to enter the channel number of the broadcast you want or
your VCR channel number.
4 Press to jump to “Confirm”, then press .
Repeat the procedure above to preset other channels manually.
Label
Assigns a name of your choice, up to five letters or numbers, to the selected channel.
AFT
Allows you to fine-tune the selected programme number manually if you feel that a
slight tuning adjustment will improve the picture quality.
Audio Filter
Improves the sound for individual channels in the case of distortion in mono
broadcasts. Sometimes a non-standard broadcast signal can cause sound distortion or
intermittent sound muting when watching mono programmes.
If you do not experience any sound distortion, we recommend that you leave this
option set to the factory setting “Off”.
~
• “Audio Filter” is not available when “System” is set to “L”.
Skip
Skips unused analogue channels when you press PROG +/- to select channels. (You
can still select a skipped channel using the number buttons.)
Confirm
Saves changes made to the “
Manual Programme Preset
” settings.