Sony BKP-7090, Installation Manual

Page: 14 / 28

1-8 (E)
BKP-7090
1
POWER
R
FILTER
LOCAL
CENTER
MARKER
SAFETY
ZONE
UP TALY
H-POSI
WIDTH
ND
1
2
3
4
5
A
B
C
D
E
CC
HEIGHT
STORE
VF DETAIL PinP
CALL
CURSOR
CURSOR ON button
VF DETAIL control
DISPLAY switch
RET 2 RET 1
V-POSI
G B
ON
OFF
DISPLAY MIX VF
ON
ON
OFF
ON
ON
1 2 3
OFF OFF
PAGE
ON
OFF
POSITION
ON
OFF
ON
OFF
CURSOR 1/2/3 button (Use to cancel)
〈
BVP-700/700P rear panel
〉
Resetting the Control Data
(1) While holding the CURSOR ON button down, push up the DISPLAY switch from ON to PAGE.
The Maintenance menu appears on the monitor screen.
(2) Set the arrow (
8
) to the “Reference Store” line by turning the VF DETAIL control and press the
CURSOR ON button. The Reference Store menu appears.
(3) Set the arrow ( 8 ) to the “All Preset” line by turning the VF DETAIL control and press the
CURSOR ON button. The control data will be reset.
(4) Set the DISPLAY switch to OFF.
Setting the System Setup (NTSC only)
(1) While holding the CURSOR ON button down, push up the DISPLAY switch from ON to PAGE.
The Maintenance menu appears on the monitor screen.
(2) Set the arrow ( 8 ) to the “System Setup” line by turning the VF DETAIL control and press the
CURSOR ON button. The System Setup menu appears.
(3) Set the arrow (
8
) to the “Select UC/J” line by turning the VF DETAIL control and press the
CURSOR ON button to select “UC”. (Every time you push this button, it changes between UC and J.)
(4) Set the DISPLAY switch to OFF.
1-3. Electrical Alignment