27
GB
BDV-N9200W/BDV-N9200WL/BDV-N7200W/BDV-N7200WL/BDV-N5200W
4-485-800-
13
(1)
D:\NORM'S JOB\SONY HA\SO140001\BDV-N9200_7200_5200_E3200
(PMRF 02)\4485800131_GB (CEK)\040GET.fm
masterpage:
Right
Getti
ng Started
2
Press
"
/
1
to turn on the system.
3
Connect the AC power cord (mains
lead) of the surround amplifier.
When wireless transmission is
activated, the LINK/STANDBY
indicator turns green.
If the LINK/STANDBY indicator does
not turn on, see “Wireless sound”
(page 70).
About the LINK/STANDBY
indicator
The LINK/STANDBY indicator shows
wireless transmission status as follows.
About the standby mode
The surround amplifier enters standby
mode automatically when the main unit
is in standby mode or wireless
transmission is deactivated.
The surround amplifier turns on
automatically when the main unit is
turned on and wireless transmission is
activated.
To specify the wireless
connection
If you use multiple wireless products or
your neighbors use wireless products,
interference may occur. To prevent this,
you can specify the wireless connection
to link the main unit to the surround
amplifier (Secure Link function). For
details, see “Further Settings for the
Wireless System” (page 53).
Step 5: Performing the
Easy Setup
Follow the Steps below to make the
basic adjustments and network settings
for the system.
Displayed items vary depending on the
area.
1
Insert two R03 (AAA) batteries
(supplied) by matching the
3
and
#
ends on the batteries to the
markings inside the
compartment.
2
Turn on the TV.
Turns green
The system is turned on, wireless
transmission is activated and surround
signals are being received.
Turns orange
The system is turned on, wireless
transmission is activated with the Secure Link
function, and surround signals are being
received.
Flashes green or orange slowly
Wireless transmission is deactivated.
Turns red
The surround amplifier is in standby mode
while the system is in standby mode or
wireless transmission is deactivated.
Turns off
The surround amplifier is turned off.
Flashes red
The surround amplifier’s protection is active.
"
/
1
LINK/STANDBY indicator
