Sony BDP S301 - 1080p Blu-ray Disc Player BD/DVD/CD Playback, Operating Instructions Manual

Page: 55 / 72

55
A
dditional
Informati
o
n
The picture does not fill the screen, even
though the aspect ratio is set in “TV Type”
under “Video Setup.”
,
The aspect ratio of the disc is fixed on your BD/DVD. See
page 45 .
The dark area of the picture is too dark/the
bright area is too bright or unnatural.
, Set “Video Control” in “A/V Control” to “Standard”
(default)
(page 28) .
, Adjust each picture setting for “Memory” in “Video
Control” to midpoint (default)
(page 28) .
Sound
There is no sound.
,
The disc is dirty or flawed.
, Re-connect the connecting cord securely.
,
The connecting cord is damaged.
, The player is connected to the wrong input jack on the
amplifier (receiver)
(page 12) .
, The amplifier (receiver) input is not correctly set.
,
The player is in pause mode or in Slow-motion Play mode.
, The player is in scan mode.
,
If the audio signal does not come through the DIGITAL
OUT (OPTICAL or COAXIAL)/HDMI OUT jack, check
the audio settings
(page 47) .
, The equipment connected to the HDMI OUT jack does not
conform to the audio signal format, in this case set “Audio
(HDMI)” in “Audio Setup” to “PCM”
(page 47) .
The sound is not output correctly.
,
Check the “Audio Output Mode” in “Speakers” Setup
(page 51) if the AUDIO OUT (L/R) jacks or the 5.1CH
OUTPUT jacks are used for audio connection.
No sound is output from the HDMI OUT jack
, Try the following:
1
Turn the player off and on again.
2
Turn the connected equipment off and on again.
3
Disconnect and then reconnect the HDMI cord.
,
The HDMI OUT jack is connected to a DVI device (DVI
jacks do not accept audio signals).
The sound volume is low.
,
The sound volume is low on some BDs/DVDs. The sound
volume may improve if you adjust the “Audio Control”
setting in “A/V Control”
(page 27) .
Operation
The remote does not function.
,
The batteries in the remote are weak (page 16) .
, There are obstacles between the remote and the player.
,
The distance between the remote and the player is too far.
, The remote is not pointed at the remote sensor on the player.
The disc does not play.
,
The disc is turned over. Insert the disc with the playback side
facing down.
, The disc is skewed.
,
The player cannot play certain discs (page 6) .
, The region code on the BD/DVD does not match the player.
,
Moisture has condensed inside the player (page 3) .
, The player cannot play a recorded disc that is not correctly
finalized
(page 6) .
, The movie file size exceeds 2 GB.
,
The file on the DATA DVD contains characters other than
numbers and English alphabet.
The MP3 audio track file cannot be played
, The DATA DVD is not recorded in the MP3 format that
conforms to UDF (Universal Disk Format).
, The audio track file does not have the extension “.MP3.”
,
The data is not formatted properly even though it has the
extension “.MP3.”
,
The data is not MPEG-1 Audio Layer III data.
, The player cannot play audio tracks in mp3PRO format.
,
Characters other than numbers and English alphabet are
contained in the file name.
The photo file cannot be played
, The disc is dirty or flawed.
,
The DATA DVD is not recorded in a JPEG format that
conforms to UDF (Universal Disk Format).
,
The file has an extension other than “.JPEG” or “.JPG.”
, The image is larger than 4,096 (width) × 4,096 (height) in
normal mode. (Some progressive JPEG files cannot be
displayed even if the file size is within this specified
capacity.)
, The image does not fit the screen (the image is reduced).
,
The photo file format does not conform to DCF* (page 41) .
, Characters other than numbers and English alphabet are
contained in the file name.
* “Design rule for Camera File system”: Image standards for digital
cameras regulated by JEITA (Japan Electronics and Information
Technology Industries Association).
The file name is not correctly displayed.
, The player can only display numbers and alphabet. Other
characters may be displayed differently.
, Depending on the writing software used, the input characters
may be displayed differently.
The disc does not start playing from the
beginning.
,
Random Play or Repeat Play is selected (page 25) .
, Resume play mode is on (page 20) .
The player starts playing the disc
automatically.
, The disc features an auto playback function.
Playback stops automatically.
, While playing discs with an auto pause signal, the player
stops playback at the auto pause signal.
(page 36) .
(page 40) .
, continued