98
Configuring System Settings ([System Setup] menu)
S
e
tti
n
g
s
When a remote camera that is not supported by the
unit is connected, its model name will appear as
“Unknown.” Some functions will not be available in
such cases.
[Tracking]:
Select whether to enable the tracking
function on a remote camera. The tracking function
will only be enabled on the last camera on which it is
configured.
•
[On]:
Enable the tracking function.
•
[Off]:
Disable the tracking function.
For details on tracking, see “Tracking Targets
(Tracking Function)” (page 66).
[System]
Configure settings related to video signals for the system
as a whole.
[System Format]:
Select the video signal format handled
by the unit (i.e., system format). The unit will shut
down if the system format is changed.
• The [60i] setting is actually equivalent to “59.94i.”
• Changes to the system format will be applied after
the unit restarts.
[HDCP Handling]:
Specify how to handle HDMI input
sources that are protected with HDCP. This setting
only applies to Input 4.
•
[Off]:
Sources protected with HDCP are not
handled. HDMI input sources that are protected
with HDCP will be treated as black signals without
audio.
•
[On]:
Sources protected with HDCP will be handled
with their protection intact.
• The following limitations apply when this is set to
[On].
– Output of signals other than HDMI is not
possible. A gray monochrome screen appears
instead.
– The [Recording] and [Streaming] functions
cannot be used. In addition, the [HDCP
Handling] setting cannot be configured while
recording or streaming is in progress.
• Sources that are protected with HDCP and input to
Input 2 will be treated as black signals without
audio, regardless of this setting.
• For details on whether your AWS-750 unit supports
the [HDCP Handling] setting, see
for “HDMI (HDMI input)
connectors 2 and 4” under “Specifications.”
[Output]
Configure settings related to video outputs.
Configure each setting after selecting a video output
connector.
When [HDCP Handling] is set to [On] in [System], output
of signals other than HDMI is not possible.
Video output connector:
Select the video output
connector you want to configure. When you select a
video output connector, the current values are
displayed for each setting item.
[Video Source]:
Select [PGM] or [AUX] for the video
output of the selected video output connector. The
selectable video signals may differ depending on the
output connector.
•
For [SDI PGM]:
The setting is fixed at [PGM].
•
For [RGB], [SDI] and [HDMI]:
Select [PGM] or
[AUX].
[Audio Source]:
Select [PGM] or [MIX] for the
embedded audio signal output of the selected video
output connector. The selectable embedded audio
signals may differ depending on the output connector.
•
For [SDI PGM]:
The setting is fixed at [PGM].
•
For [HDMI] and [SDI]:
Select [PGM] or [MIX].
[Video Format]:
Select the signal format that will be
output to each video output connector.
When [Auto] is selected for RGB or HDMI, the unit
and output destination device are linked and the
optimal signal is output, and the video will be
displayed at the resolution of that signal.
Tip
Tips
Notes
Note
Tip
Video output connectors
Summary of Contents for AWS-750
Page 121: ......
