Sony Anycast station AWS-G500, Operating Instructions Manual

Page: 67 / 316

67
Settings Related To Input Signals
Ch
apt
er 2 Prep
ar
at
ions
Video Signal Related Settings
These are preparations for handling video signals with the unit.
Assigning video input signals to the selection buttons
Assign video signals to the selection buttons 1 - 6 (PGM selection and NEXT
selection buttons).
You can confirm assignments and information on input signals using each of the
corresponding ACCESS menus. The signal names displayed in the menus are
those of signals that are capable of being accepted as determined by the unit. Not
all standard signal names are displayed.
1
Press the MENU button.
2
In the top menu, select [Video Input Assign].
3
From the list select the number of the selection button, and confirm, then set
the following items in the submenu.
Assigning a name for the video
Assign a name for the video. The name assigned here appears in the source
viewer with the same number as the selection button.
1
Select [Source Name], and confirm;
2
enter the name in the input box,
and confirm.
Specifying a video input connector
Specify the video input connector to which the video signals assigned to the
selection button are input.
1
Select [Input], and confirm;
2
select the video input connector from the
list, and confirm.
Note
1
2
3
4
5
6
Source Name
Input S1-1 Composite
Source Aspect 4:3
Control Off
[
CAM1
]
1 2
Enter up to 20 characters.
* The source viewer can only
display a limited number of
characters.
1
2
3
4
5
6
Source Name
Input S1-1 Composite
Source Aspect 4:3
Control Off
No Assign
B SLOT1 IN1 Composite
S-Video
DV
SLOT1 IN2 Composite
S-Video
DV
SLOT2 IN1 Composite
S-Video
DV
SLOT2 IN2 Composite
S-Video
DV
SLOT3 IN1 RGB
SLOT3 IN2 RGB
1 2