76
Searching Using Various
Functions
The VCR automatically marks the tape with an
index signal at the point where each recording
begins.
You can easily find a specific point using various
search functions.
Note
During DVD recording, you cannot use VCR search
functions.
1
Press VIDEO to operate the VCR.
2
Press OPTIONS.
3
Select a search method from the OPTIONS
menu, and press ENTER.
“Go to Zero”: Searches for the 0:00:00 point
on the tape counter.
To reset the counter to 0:00:00, press CLEAR.
“End Search”: Searches for the beginning of a
blank space. If no blank space is found, the
tape will reach the end.
“Forward Intro Scan”/“Reverse Intro Scan”:
Searches for an index mark and plays back for
about five seconds at that point.
Press
H
(play) to view that programme. If
you do not press
H
, the VCR automatically
searches for the next index mark, or until it
reaches the end of the tape.
Notes
• The VCR may not recognize the end of a blank space
depending on its length.
• No index signal is marked if you pause a recording and
then keep recording the same programme. To mark an
index, press
x
or change the programme position once
during recording pause.
1
1
2
2
3
3
4
4
5
5
6
6
7
7
8
8
0
0
9
9
M
/
m
/
<
/
,
,
ENTER
H
VIDEO
OPTIONS
CLEAR
ENTER Enter
Go to Zero
End Search
Forward Intro Scan
Reverse Intro Scan
Move
0:00:00
Go to Zero
0:00:13
End search
–0:00:01
Scan and play
Summary of Contents for 3-213-480-12(1)
Page 131: ......
Page 132: ...Sony Corporation Printed in Indonesia AK68 01481A ...
