122
On the LCD screen
• Do not exert excessive pressure on the LCD
screen. Blurs appear and it may cause a
malfunction of your camcorder.
• If your camcorder is used in a cold place, a
residual image may appear on the LCD screen.
This is not a malfunction.
• While you are using your camcorder, the back of
the LCD screen may heat up. This is not a
malfunction.
x
To clean the LCD screen
If fingerprints or dust make the LCD screen
dirty, use the cleaning cloth (optional) to
clean the LCD screen.
When you use the LCD Cleaning Kit
(optional), do not apply the cleaning liquid
directly to the LCD screen. Use cleaning
paper moistened with the liquid.
x
On adjustment of the LCD screen
(CALIBRATION)
The buttons on the touch panel may not work
correctly. If this happens, follow the
procedure below. It is recommended you
connect your camcorder or the Handycam
Station to the wall outlet with the supplied
AC Adaptor during the operation.
1
Slide the POWER switch to light up the
(PLAY/EDIT) lamp.
2
Remove cables other than that of the AC
Adaptor from your camcorder or the
Handycam Station.
3
Touch
t
[SETUP]
t
STANDARD SET
t
[CALIBRATION].
4
Touch the “
×
” displayed on the screen with
a thin object such as a corner of
“MemoryStick Duo”.
The position of the “
×
” changes.
Touch [CANCEL] to cancel.
If you did not press the right spot, try the
calibration again.
• Do not use a sharp-pointed tool to calibrate the
LCD screen. Doing so may damage the surface
of the screen.
• You cannot calibrate the LCD screen if you have
rotated it, or if you have set it with the LCD screen
side facing out.
On handling the casing
• If the casing is soiled, clean the camcorder body
with a soft cloth lightly moistened with water, and
then wipe the casing with a dry soft cloth.
• Avoid the following to prevent damage to the
finish.
– Using chemicals such as thinner, benzine,
alcohol, chemical cloths, repellent and
insecticide and sunscreen.
– Handling with above substances on your hands.
– Leaving the casing in contact with rubber or
vinyl objects for a long period of time.
Care and storage of the camera lens
• Wipe the surface of the lens clean with a soft cloth
in the following instances:
– when there are fingerprints on the lens surface.
– in hot or humid locations
– when the lens is exposed to salty air such as at
the seaside.
• Store the lens in a well-ventilated location subject
to little dirt or dust.
• To prevent mold, periodically clean the lens as
described above. It is recommended that you
operate your camcorder about once a month to
keep it in optimum state for a long time.
To charge the pre-installed
rechargeable battery
Your camcorder has a pre-installed
rechargeable battery to retain the date, time,
and other settings even when the POWER
switch is set to OFF (CHG). The pre-installed
rechargeable battery is always charged while
you are using your camcorder but it will get
discharged gradually if you do not use your
camcorder. The rechargeable battery will be
fully discharged in
about 3 months
if you
do not use your camcorder at all. However,
even if the pre-installed rechargeable battery
is not charged, the camcorder operation will
not be affected as long as you are not
recording the date.
CALIBRATION
Touch the "x".
1/3
CANCEL
Summary of Contents for 1070
Page 12: ...12 Maintenance and precautions 121 Glossary 124 Index 126 Glossary Index ...
Page 130: ...130 ...
Page 131: ...131 ...