Sontay SonNet Trend, Technical Manual

Page: 25 / 220

SIP SonNet-Trend - Interface Range
Contents
1 INTRODUCTION ...................................................................................................................................... 1
1.1 THE UNIT 3
1.1.1 Front Panel Annunciation ............................................................................................................... 3
1.1.2 Button and Switches ....................................................................................................................... 4
1.2 SYSTEM OVERVIEW .............................................................................................................................. 5
1.2.1 SonNet Network ............................................................................................................................. 6
1.2.2 Trend Network ................................................................................................................................ 6
2 HARDWARE GUIDE ................................................................................................................................ 7
23 Issue 1, Jun. 2014
3.2 HARDWARE CONTROL
The unit is fitted with 1 switchbank of 4 poles that are used to define the Serial port interface. It
will be set to RS232 by default. A combination of pole 1 (SW1:p1) and pole 2 (SW1:p2) are used
to configure the communications standard of Serial port 1 (
P1
).
The switch 3 (SW1:p3) and switch 4 (SW1:p4) are not supported.
SWITCH NO. (SW1) RS232 SIGNAL
1 (SW1:p1) ON
2 (SW1:p2) ON
3 (SW1:p3) N/A
4 (SW1:p4) N/A
Note This unit also supports RS485 (2-wire+Gnd), and RS422 (4-wire+Gnd). However,
these wiring standards are not applicable to the SonNet RX-RFS wireless
receiver.
1
DI
2 3 4
ON