SonoSite iLook, User Manual

Page: 29 / 102

Chapter 3: The Exam
21
Exam
Chapter 3: The Exam
This chapter contains detailed information about preparing for the exam, adjusting imaging modes,
performing a distance measurement, manipulating a frozen image, and saving and reviewing
images.
Prepare for the Exam
The correct patient information helps identify saved, recorded, and printed images.
See
“To adjust system settings (second page):” on page 17 for date and time setting instructions.
To apply acoustic coupling gel:
Apply a liberal amount of gel between the transducer and the body.
Acoustic coupling gel must be used during exams. Although most gels provide suitable acoustic
coupling, some gels are incompatible with some transducer materials. SonoSite recommends
Aquasonic
®
gel and a sample is provided with the system.
To install a transducer cover:
Note: SonoSite recommends the use of market-cleared, transducer sheaths for clinical applications of an
invasive nature.
1
Place gel inside the sheath.
2
Insert the transducer into the sheath.
Warning:
Verify that the patient information, date, and time settings are accurate.
Caution:
Do not use the system if an error message appears on the image display. Note the
error code. Call SonoSite or your local representative. When an error code occurs,
turn off the system by pressing and holding the power switch until the system
powers down. If the power switch does not respond, remove all power sources.
Caution:
Using gels not recommended for your transducer can damage it and void the
warranty. If you have questions about gel compatibility, contact SonoSite or your
local representative.
Warning:
Some transducer sheaths contain natural rubber latex and talc, which can cause
allergic reactions in some individuals. Refer to 21 CFR 801.437, User labeling for
devices that contain natural rubber.
Caution:
SonoSite recommends you clean transducers after each use. See “Cleaning and
Disinfecting Transducers” on page 61 .