Sonoro PRIMUS SO-340, Operating Manual

Page: 72 / 336

72 © sonoro audio GmbH 2021
3. Getting started
3.1 Unpacking PRIMUS
1. Take PRIMUS out of the packaging and check whether PRIMUS or the
individual parts exhibit damages. If this is the case, do not use PRIMUS.
Should you detect any damage, contact your dealer or sonoro audio GmbH
customer support immediately.
2. Check to make sure that the delivery is complete (see chapter “Scope of
delivery”).
3. Place PRIMUS at a suitable location. If you want to put your PRIMUS on a
natural wood surface, please make sure that it is suitable. On oiled and
waxed surfaces may possibly cause stains.
4. Remove the protective film from the display.
3.2 Inserting the battery in the remote control
1. Open the battery compartment cover on the back of the remote control by
turning it anticlockwise using a small coin.
2. Insert the supplied batteries (CR2032, 3 V) with the label (+) side up.
3. Replace and close the battery compartment cover by turning the cover
clockwise using a small coin.
Do not block the infra-red sensor on the PRIMUS and the infra-red
transmitter on the remote control during use.