Sonnen sonnenBatterie 10, Installation Instructions Manual, Page: 29 / 100

Installing the storage system | 5
KD-557 | 1000241 | EN | 02 29 / 100
5.3 Routing cables into the system
The specified degree of protection for the storage system and therefore touch
protection and protection against the ingress of water and foreign bodies is
only achieved when all openings on the storage system are sealed as described
in the product documentation.
• The openings on the mounting frame are sealed with cable entry plates and dummy
plugs.
• All cables to be routed into the storage system must be directed through the designated
cable entry plate.
6 3 4 5
1
2
No. Type Use
1 Dummy plug (Ø 40) Reserve (DC module)
2 Cable entry point (Ø 32) with grommet for two lines Modbus cable, Ethernet cable
3 Dummy plug (Ø 50) Reserve (sonnenProtect 4000)
4 Cable entry point (Ø 20.5) for one line Signal line for digital input/outputs
5 Cable entry point (Ø 20.5) for one line AC cable
6 Dummy plug (Ø 50) Reserve (extension cabinet)
„
The position and type of cable entry point designated in each case can be seen in the
figure.
„
Use the cable entry points and grommets, if any, from the accessories set to direct the
cables into the storage system.
„
Seal the remaining openings using he dummy plugs provided for this purpose in the ac-
cessories set.