Instructions for Assembly and Operating
SONIX 30D
10
E1
Upper threshold
Lower threshold
E2
Diagnostic screen
The current flow in m
3
/h and the counted total volume in m
3
For positive flow the volume counter counts up. For negative flow the counter
can stop counting or can count down.
Power failure does not cause deletion of volume counter data or the loss of
other data and parameters.
It is possible for the user to program the number (0...3) of displayed
decimals.
Threshold programming is available in the user’s functions.
On E1 screen are only displayed the programmed flow thresholds above and
below. Only one treshold can be used at a time. It is available on OC output.
Upper line, from left:
-Flow speed in m/s
-Type and 2 digits value of amplification adjustment: r-manual adjusting, a-
automatic adjusting
-Desired and current mode of work:
0 – lack of liquid
1 – works only on the AB path
2 – works only on the CD path
3 – works only on the EF path
4 – work only AB and CD paths
5 – work only CD and EF paths
6 – work only AB and EF paths
7 – 3 paths measurement
Diagnostic messages are displayed in the lower line:
‘Measurement OK’
‘Empty pipe’ – empty pipeline or disconnected probes
‘Low signal' – decreasing of the signal from pair of probes
'Out of I range' – flow exceeding the current range of flowmeter
'Out of v range' – too high liquid speed
'Disturbances' – more than 50% of interfered measurements
'Inconsistency' – mode of work or CRC inconsistency
'Adjustment' – ultrasonic signals are adjusting
E0
Flow
Volume
Descriptions of the menu
Basic main screens
Nr
Button
Upper line
Bottom line
E0
Current flow
Total volume
E1
Right
Upper threshold
Lower threshold
E2
Right
Diagnostic data
Diagnostic message
E3
Right
Diagnostic messages
Diagnostic messages
E4
Left
Working time
Time of correct work
E5
Left
Factory number L
Program version CRC
E6
Left
SONIX
SONIX phone nymber
E7
Both
Access code
****