31
Dante Controller
4
31
Controls, Indicators and Connections
5
Status LEDs (A)
The status LEDs are located in the top right corner of the overlay on the
AVN-CU2 and in the top right corner of the first overlay on the AVN-CU4.
Clock
The PTP clock is used to keep audio streams in sync.
• Green - The device is a PTP master or slave.
• Red - PTP sync lost.
AoIP
• Green - Valid AoIP connection on the corresponding connector.
• Off - No valid AoIP connection on the corresponding connector.
PoE
• Green - PoE is available on the corresponding connector.
• Red - PoE is unavailable on the corresponding connector.
• Off - LED disabled via the embedded web server.
AC PSU
This applies to the AVN-CU4 only.
• Green - A safe level of power is available on the AC power supply input.
• Red - The power on the AC power supply input is at an unsafe level or no
AC power supply is connected.
• Off - LED disabled via the embedded web server.
DC PSU
• Green - A safe level of power is available on the DC power supply input.
• Red - The DC power supply input is at an unsafe level or no DC power
supply is connected.
• Off - LED disabled via the embedded web server.
TFT Display (B)
A TFT display is located to the left of the encoders. The TFT is split into six
encoder sections and a top section which displays the currently selected
page number and the metering of a chosen output. The encoder sections
below this contain information about the assigned audio source,
destination, or mix point.
Encoders (C)
Each of the encoders are assigned to their corresponding encoder section
on the TFT display and provide adjustment of the level and pan of the
audio. The encoders are also used to navigate and adjust values within the
system menu. Situated to the right-hand side of each encoder is an LED
which is illuminated in a colour which corresponds to the ‘encoder section’
it controls.
Illuminated Buttons (D)
The AVN-CU2-DANTE has 12 illuminated push buttons, the AVN-CU4-DANTE
has 24. Each button has a removable cap to allow the user to modify the
label on the button. The action, colour and function of each button can be
configured via the embedded web server.
