INVISIBLE SERIES NARROW SOUND ISOLATING ENCLOSURE
INSTALLATION INSTRUCTIONS
INTRODUCTION
Sonance Invisible Series Narrow Sound Isolating
Enclosures reduce sound transmission into rooms
that are adjacent to speakers mounted in walls or
in ceilings. For the enclosures to be effective, it
is important that they are installed according the
following directions to ensure a tight seal with the
speaker.
INSTALLATION
Step 1
Place the speaker on a flat surface. Route the wire
from the IS speaker through the air tight connector
on the enclosure. You might need to loosen the nut
on the air tight connector to allow the wire to pass
through easily.
Step 2
Place the enclosure over the back of the speaker. Use
the provided self tapping screws to attach the
enclosure to the speaker while applying light pressure
to the back of the enclosure to ensure an air tight seal.
To ensure that the gasket sits properly, tighten the
screws in a crisscross and diagonal pattern. Apply an
equal amount of torque to each screw.
NOTE: SCREWS ARE #6x1” FLAT HEAD TYPE.
IMPORTANT: ALWAYS USE LOW-TORQUE
SETTINGS. NEVER OVER TIGHTEN.
Step 3
Tighten the nut on the air tight connector to seal up
the enclosure and capture the speaker wire. Connect
the wires from your amplifier to the speaker wires
normally.
NOTE: ALL NARROW SOUND ISOLATING
ENCLOSURES INCREASE THE MOUNTING DEPTH OF
THE INVISIBLE SERIES SPEAKERS TO 7.67” (195MM).
MODELS IS8T AND IS15W INCLUDE THE ENCLOSURE
BUILT IN AND DO NOT REQUIRE THIS ACCESSORY.
NOTE: THE MOUNTING WIDTH OF ALL NARROW
SOUND ISOLATING ENCLOSURES IS 10.43” (265MM).
ALL MODELS ARE DESIGNED TO BE USED WITH 16”
(406.4MM) ON CENTER TJI JOIST SPACING.
Note: Contact Sonance Technical Support for replacement screws.
For additional information
please scan the code.
