81
2-14-2. GP-1019 Board, HN-449 Board
Preparation
1. Remove the handle upper cabinet assembly. (Refer to “2-14-1. Handle Upper Cabinet Assembly”.)
Procedure
1. Disconnect the flexible board from the connector on the GP-1019 board.
2. Remove the precision screw, and then remove the GP-1019 board.
Note
At the time of the installation, make sure that the two bosses shown in the figure are inserted firmly into the two holes on the
GP-1019 board.
3. Remove the three precision screws, and then remove the bracket (GP).
Holes
Bosses
Precision screw
(P2 x 4)
GP-1019 board
Connector
Flexible board
Bracket (GP)
Precision screws
(P2 x 4)
