Roll-Up 28 Wirefree™ RTS
Quick Programming Guide
P-0039CBG
INITIAL PROGRAMMING AND LIMIT SETTING
Step 2:
Check the direction of
operation. Press the
DOWN
button
and confirm the shade lowers.
Step 5:
PRESS & HOLD
the
MY/STOP
button until
the shade jogs to confirm
both limit settings.
Step 3:
Bring the shade to your desired upper
limit.
PRESS & HOLD
both the
MY/STOP and
DOWN
buttons until the shade begins to move
down, then release. Stop the shade at the desired
lower limit, adjust by pressing the
UP
or
DOWN
.
Step 6:
To finalize
BRIEFLY PRESS
the
PROGRAMMING
BUTTON
on the back of the control. The shade will jog and
will now operate in
user mode
. A brief press of the UP or
DOWN button will send the shade to the respective limit.
Step 1:
To initiate programming
PRESS
& HOLD
the
UP and DOWN
buttons at the
same time until the shade jogs.
Step 4:
PRESS & HOLD
the
UP
and MY/STOP
buttons until the
shade begins to move up.
The shade will stop at the original
upper limit. Adjust if necessary.
Programming
Button
If the shade raises instead of closing, change the direction -
PRESS & HOLD
the
MY/
STOP
button until the shade jogs. Confirm correct direction of operation before proceeding.
ADJUSTING THE LIMITS IN USER MODE
LOWER LIMIT
UPPER LIMIT
Step 4:
PRESS & HOLD
the
MY/STOP
button until the
shade jogs, then release. Check the new limit.
Step 3:
Adjust to a new limit position using the
UP
or
DOWN
buttons.
Step 2:
PRESS & HOLD
both
UP and DOWN
buttons
simultaneously until the shade jogs, then release.
Step 1:
Move the shade to the current limit position you
wish to adjust and let it stop.
Copyright © Somfy SAS 5/2019
NOTE:
Motor will exit programming mode after 2 minutes of inactivity. While in
programming
mode
, the shade only operates when UP or DOWN buttons are continuosly pressed.
BEFORE YOU BEGIN: Check if you have a paired remote with the following directions:
1)
Supply power to the motor by connecting the power source to the power cable on the motor.
2) If a remote was ordered, press a directional button (UP or DOWN) and see if the shade operates. If a multi-channel
remote was ordered, select the channel the shade should be programmed under then operate the shade.
a) If the shade operates - the shade is already programmed.
b) If the shade does not operate - choose the channel on which you would like to control the shade.
PRESS & HOLD
the
PROGRAMMING BUTTON on the motor
until it jogs once. Then
BRIEFLY PRESS
the
PROGRAMMING BUTTON
on the remote.
The shade will jog once. The shade is now programmed.
NOTE: Upper and lower limits are set at the factory. In the event limit setting is required, please follow
steps under Initial Programming and Limit Setting.
