SOMFY Sonesse 40 RS485, Instructions Manual

Page: 3 / 112

Sonesse 40 RS485 EN
Copyright © 2021 SOMFY ACTIVITES SA. All rights reserved. 3
The installer, who must be a motorisation and home automation professional, must ensure that the motorised product is
installed in accordance with the standards in force in the country in which it is installed such as EN 13120 relating to interior
blinds.
1.2.Liability
Before installing and using the drive, please read these instructions carefully .
In addition to the instructions provided in this guide, please also comply with the instructions provided in the attached Safety
instructions document.
The drive must be installed by a home motorisation and automation professional, in accordance with Somfy’s
instructions and the applicable regulations in the country of installation
.
Any operation of the drive outside the field of application described above is prohibited. Such use, and any failure to comply
with the instructions given in this guide and in the attached
Safety instructions document, absolves Somfy of any liability and
invalidates the warranty.
After installing the drive, the installer must inform his customers of the operating and maintenance conditions for the drive
and must provide them with the operating and maintenance instructions, and the attached
Safety instructions document.
Any After-Sales Service operation on the drive must be performed by a home motorisation and automation professional.
Never begin installing without first checking the compatibility of this product with the associated equipment and
accessories. If in doubt when installing this product and/or to obtain additional information, contact a Somfy representative
or visit the website
www.somfy.com .
2.INSTALLATION
WARNING
• These instructions are mandatory for the home motorisation and automation professional installing the drive.
• Comply with current standards and legislation in the country of installation.
CAUTION
• Never drop, knock or puncture the drive or immerse it in liquid.
• Install an individual control point for each drive.
• To insure optimized silent operation, the gaps between the drive, the accessories, the tube and the tube end piece
must be minimized.
2.1.Assembly
2.1.1.Replace the head cover with a different color (Optional)
1] Remove the screw.
2] Replace the cover with a new cover.
3] Screw the cover at 0,4 N·m.
NOTICE
Head has interchangeable covers to fit with the fabric.
2.1.2.Preparing the drive
ü
Check that the inner diameter of the motorised product’s tube is greater than 37 mm.
1] Fit the accessories required to integrate the drive into the winding tube: fit the
crown (a) and the drive wheel (b) to the drive.
a
b