Sonesse
®
30 RTS 24V DC
Quick Programming Guide
IMPORTANT: Upper and lower limits are set at the factory. In the event limit setting is required, please follow steps under INITIAL PROGRAMMING AND LIMIT SETTING.
TO FINISH PROGRAMMING:
1)
Supply power to the motor
(see example under WIRING
). The LED on the motor will flash Orange
twice
(repeating every 10 seconds)
2) Choose the transmitter you wish to control the shade and choose the appropriate channel for control.
3)
PRESS & HOLD
the
UP
and
DOWN
buttons on the transmitter until the shade jogs
once
.
4)
BRIEFLY PRESS
the
PROGRAMMING BUTTON
on the transmitter to pair the control to the motor. The motor will jog
once
.
The LED on the motor will flash Green
5 times
then stop flashing.
The co
ntrol is now paired to the motor.
Copyright © Somfy SAS
www.somfysystems.com
SAFETY
•
Before installation, check that this product is compatible with the associated equipments and acces sories.
•
Moreove
r,
the installer must comply with current standards and legislation in the country in which the product is being installed, and inform his customers of the
operating and maintenance conditions for the product.
NOTE:
Motor will exit programming mode after 2 minutes of inactivity. Prior to confirming limits, the shade only operates when the
UP
or
DOWN
buttons are continuously
pressed. Releasing the buttons stops the shade.
INITIAL PROGRAMMING AND LIMIT SETTING
Step 2:
To initiate programming
PRESS & HOLD
both the
UP
and
DOWN
buttons at the
same time until the shade jogs.
Step 1:
Supply power
to motor.
Step 6:
PRESS &
HOLD
the
MY/STOP
button until the shade
jogs to confirm both limit
settings.
Step 4:
Bring the shade to your desired upper
limit.
PRESS & HOLD
both the
MY/ STOP
and
DOWN
buttons until the shade begins to move
down, then release. Stop the shade at the
desired lower limit, adjust by pressing the
UP
or
DOWN
buttons.
Step 7:
T
o finalize
BRIEFLY PRESS
the
PROG button
on the back of the remote
.
The shade will jog and will now operate
in
user mode
. A brief press of the
UP
or
DOWN
button will send the shade to the
respective limit.
Step 5:
PRESS & HOLD
the
UP
and
MY/STOP
buttons until the shade
begins to move up. The shade will
stop at the original upper limit.
Step 3:
Check the direction of
operation. Press the
DOWN
button
and confirm the shade lowers.
If the shade raises instead of lowering, change the di
r
ection
-
PRESS & HOLD
the
MY/STOP
button until the shade jogs.
Confirm co
rr
ect di
r
ection of operation befo
r
e proceeding.
Programming
Button
WIRING
Connect the power cable to the motor.
Programming
Button
