Rollixo Smart io
EN
Copyright
©
2020 SOMFY ACTIVITES SA. All rights reserved.
41
Function of the 3-button remote control buttons
Function
Up button
My button
Down button
Complete opening
Complete opening
Stop
Complete closing
Aux. 230 V
Aux. output ON
Aux. output OFF
8
PROGRAMMING ON AN IO LIGHT RECEIVER
This function enables automatic activation of remote lighting connected to the receiver during garage door
movements.
1]
Switch the light receiver to programming mode (refer to the receiver manual).
2]
Briefly press the "PROG" button.
ð
The PROG indicator light flashes once.
ð
The lighting connected to the light receiver comes on and then goes out.
9
CLEARING THE REMOTE CONTROLS AND ALL SETTINGS
9.1
Clearing the memorised remote controls
> > > Illustration 24
Press the "
PROG
" button for 7 s until the "PROG" indicator light flashes.
Clears all memorised remote controls.
9.2
Deleting the settings
> > > Illustration 25
Press the "
SET
" button for 7 seconds until the "POWER" indicator light flashes quickly.
This causes all settings to be reset to the default values.
10 LOCKING THE PROGRAMMING BUTTONS
> > > Illustration 26
WARNING
The keypad must be locked to ensure user safety.
Failure to follow this instruction may result in serious injury, e.g. due to crushing by the door.
Press the “
SET
”, “
+
” and “
-
” buttons simultaneously.
The programmes are locked. The parameter setting indicator lights come on when the programming but-
ton is pressed.
To access the programming again, repeat the same procedure.
