inteo
LIGHTING indoor RTS
INSTALLATION
guide
Ref.5004240
■
Main supply : 220-240V
~
■
Fuse : 3,15A
■
Class II product
■
Protection index : IP30
■
Load : incandescent or halogen
lamps 500 W max.
■
Radio frequency : 433.42 MHz
■
Operating temp. : +5°C to +40°C
1
Characteristics
2
Installation
Recommandation of mounting for better radio
reception :
minimum distance between LIGHTING indoor RTS
and the floor : 1,5 m.
minimum distance between a LIGHTING indoor
RTS and a radio transmitter : 30 cm.
minimum distance between two LIGHTING indoor
RTS : 20 cm.
Warning : cordless radio equipment (e.g.
headphones) in 433MHz can affect the fun-
ctionning of the LIGHTING indoor RTS.
The
LIGHTING indoor RTS
is a radio receiver dedicated to control an incandescent or
halogen lamp with an RT or RTS control (no lamp with gear).
Up to twelve different controls can be memorized in the memory of the
LIGHTING
indoor RTS
allowing individual, group and master commands.
This device must be installed and programmed by qualified installers for whom
this instruction is intended.
3
Programming and operating
3.1 Record the first control
R
PROG
▲
,S,
▼
,S
RTS control : press briefly the “prog” button.
RT control : remove the battery, press briefly the button, replace the batte-
ry and press again briefly the button.
➜
The lamp lights during 2 secs. again and the LED of the LIGHTING
indoor RTS blinks during 5 sec. The control has been recorded.
Set the LIGHTING indoor RTS in its programming mode :
Record the first control :
80 mm
80 mm
45 mm
fuse
programming
button
manual
control button
LED
Neutral
POWER
SUPPLY
Phase
L
N
Phase
Neutral
Output
Do not use
N
X
L
2 s
➜
Press for more than 2 seconds on the programming button of
the LIGHTING indoor RTS.
➜
The LED of the LIGHTING indoor RTS lights on and the
lamp lights for 2 secs.
The LIGHTING indoor RTS is in programming mode for one
minute.
R
PROG
▲
,S,
▼
,S
R
PROG
▲
,S,
▼
,S
R
PROG
▲
,S,
▼
,S
➜
3V
LITHIUM
RENA
TA
CR 2032
3V
LITHIUM
RENA
TA
CR 2032
S
W
IS
S
M ADE
3V
LITHIUM
RENA
TA
CR 2032
3V
LITHIUM
RENA
TA
CR 2032
S
W
IS
S
M ADE
0,5 s
0,5 s
0,5 s
or
5 s
2 s
2 s
1
2
ø 60
60
Recessed mounting :
Surface mounting :
Hereby, SOMFY, declares that this equipment is in com-
pliance with the essential requirements and other rele-
vant provisions of Directive 1999/5/EC.
A Declaration of Conformity is available at the web
address
www.somfy.com Heading CE
