24
CONNECTED LOCK
Installation
• (1) Position the metal backing plate
on the door
- Place the side protected by the rubber
layer facing the door.
- Use double-sided tape on the rear
of the plate to help you position it.
• (2) Fix the backing plate on the cylinder
- Using 2 screws and the screwdriver supplied.
- Depending on the distance between the cylinder and the backing plate,
choose screws
of appropriate length
(supplied in the box of the new cylinder).
1
2
inside
2. INSTALL
THE CONNECTED LOCK /
B.
Fix the connected lock
For locks with escutcheon or rosette, refer to the indication at
the bottom of page.
A
B
C
D
- Loosen the bottom screw (A)
- Position the plate over the escutcheon
- Tighten the screw into the slot provided for this purpose (B)
- Loosen the fixing screws (C)
- Position the plate over the rosette
- Tighten the screw into the holes provided for this purpose (D)
Escutcheon or rosette:
In addition to the steps (1) and (2) you can also use the fixing screws of these
to consolidate the installation:
© 2017 Somfy SAS. All rights reserved - Images for illustration purposes only.
