animeo IB+
4 Zone/8 Zone TouchBuco BACnet
2020/04/30
Seite 5
Caution:
1. "Down Command" means that the end products/motorized products (roller shutters, Venetian blinds,
etc.) are being lowered or that a window is being opened.
2. "Up Command" means that the end products/motorized products (roller shutters, Venetian blinds, etc.)
are being raised or that a window is being closed.
The following errors should be eliminated by a specialist:
1. Several or all drives move in the wrong direction.
Cause: The up and down connections on the drive of the motor controller have been swapped.
2. The motor controller (for 1, 2, 4 or 6 drives) does not execute any command.
Possible causes:
•
The motor control unit has no mains voltage.
•
The bus is not correctly connected (pay particular attention to "com" and "IB+" wires).If your system is
connected correctly, the red LED on the motor controller will light up as soon as a command is
received here. If this is not the case, please have your system checked again by your specialist
dealer.
3. Several drives are not being activated (i.e. they do not move to the intended position).
Possible causes:
•
Check the fuses on the motor controller (only for 4-unit device).
•
The thermal protection may have been activated on one drive (e.g. after many long movements). Wait
15 minutes and then repeat the test.
1.6 Choose Weather Station
You can choose from five options here:
1. Compact Sensor (compact weather station) with integrated sensor (wind, sun, outside temperature,
rain).
2. Outside Sensor Box (large weather station with connection box) to which multiple individual sensors can
be connected.
3. M8 (weather station) with integrated sensor (wind, 4 x sun, outside temperature, rain).
4. M13 (weather station) with integrated sensor (wind, wind direction, 8 x sun, outside temperature, rain).
5. Not used (e.g. for demo purpose).
Have the weather station installed by a specialist. Please pay attention to the installation instructions (e.g.
with regards to sensor alignment).
Selecting "Master": When using one TouchBuco unit with one weather station, this must be set up as
"Master".
When operating multiple TouchBuco units with one weather station, one TouchBuco must be selected as
"Master". All other TouchBuco units must NOT be selected as "Master", as this can lead to communication
problems.
Summary of Contents for animeo IB+ 4 Zone Touch Building Controller
Page 49: ......