40
Note:
Some older model HDDs don’t provide this feature.
Primary
Choose Auto (default) or Mode 0~4. The BIOS will
Master/Slave PIO
detect the HDD Mode type automatically when you
Secondary
choose Auto. You need to set to a lower mode than
Master/Slave PIO
Auto when your hard disk becomes unstable.
Primary Master/
Ultra DMA/33 implementation is possible only if your
Slave UDMA
IDE hard drive supports it and the operating
Secondary Master/
environment includes a DMA driver (Windows 95
Slave UDMA
OSR2 or a
third-party IDE bus master driver). If your
hard drive and your system software both support
Ultra DMA/33, select Auto to enable BIOS support.
The Choice: Auto, Mode 0, Mode 1, Mode 2.
Onboard FDC
Choose Enabled (default) or Disabled. Choose
Controller
Disabled when
you use an ISA card with FDD function,
or , choose Enabled to use the onboard FDD
connector.
Onboard Serial
Choose Auto (default), 3F8/IRQ4, 2F8/IRQ3,
Port 1
3E8/IRQ4, 2E8/IRQ3, or Disabled. Do no set port 1 &
2 to the same value, except when setting at Disabled.
Onboard Serial
Choose Auto (default), 3F8/IRQ4 , 2F8/IRQ3,
Port 2
3E8/IRQ4, 2E8/IRQ3, or
Disabled.
UART 2 Mode
Choose Standard (default), HPSIR, or ASKIR.
IR Function
Choose Half or Full.
Duplex
Onboard Parallel
Choose the printer I/O address:
Port
378H/IRQ7 (default), 3BCH/IRQ7, 278H/IRQ5,
Disabled
Onboard Parallel
Choose Normal (default), ECP/EPP EPP, or ECP
Mode
mode. The mode depends on the external device
connected to this port.
ECP Mode Use
Choose DMA3 (default) or DMA1. Most sound cards
DMA
use DMA1. Check with your sound card configuration
to make sure that there is no conflict with this function.
*:
This option will not be displayed unless the EPP/ECP function is
selected..