The same as traditional HID lighting. There are two installation methods, suitable for various
occasion.
An internal power-factor-corrected switch-mode supply allows it to be used from
any nominal 100-277V&277-480V, 50~60Hz AC supply without any variation in light
output.
Suitable for use in the following locations:
•
Ambient Temp: -40~+40°C
•
Wet Locations
Note
: Save these instructions for future reference.
2.
Installation
For supply connections use wire rated for at least 90
°
C
Installation Steps:
Refer to the following diagram when you install the fixture. Seven installation methods, directly fix to the
mounting surface or fix to a post with a knuckle.
1.Directly fix to mounting surface
Warning:
To avoid the risk of fire, explosion, or electric shock, this product should be installed,
inspected, and maintained by a qualified electrician only, in accordance with all applicable
electrical codes.
Warning:
To avoid electric shock:
•
Be certain electrical power is OFF before and during installation and maintenance.
•
Luminaire must be connected to a wiring system with an equipment-grounding conductor.
Warning:
To avoid explosion:
•
Make sure the supply voltage is the same as the rated luminaire voltage.
•
Do not install where the marked operating temperatures exceed the ignition temperature of
the hazardous atmosphere.
•
Do not operate in ambient temperatures above those indicated on the luminaire nameplate.
•
Keep lens tightly closed when in operation.
TLFLK100PXYYZZ/TLFLK100PHXYYZZ
TLFLK150PXYYZZ/TLFLK150PHXYYZZ
TLFLK200XYYZZ
TLFLK230PXYYZZ/TLFLK230PHXYYZZ
TLFLK300PXYYZZ/TLFLK300PHXYYZZ
TLFLK400PXYYZZ/TLFLK400PXYYZZ
STL-FLK100PXYYZZ/STL-FLK100PHXYYZZ
STL-FLK150PXYYZZ/STL-FLK150PHXYYZZ
STL-FLK200PXYYZZ
STL-FLK2300PXYYZZ/STL-FLK230PHXYYZZ
STL-FLK300PXYYZZ/STL-FLK300PHXYYZZ
STL-FLK400PXYYZZ/STL-FLK400PHXYYZZ
To avoid the rish of fire, explosion or electric shock, this product should be installed,
inspected, and maintained by a qualified electrician only, in accordance with all applicable
electrical codes.
To avoid electric shock:
- Be certain electrical power is OFF before and during installation and maintanence.
- Luminaire must be connected to a wiring system with an equipment-grounding conductor.
To avoid explosion:
- Make sure the supply voltage is the same as the rated luminaire voltage.
- Do no install where the marked operating temperatures exceed the ignition temperature
of the hazardous atmosphere.
- Do not operate in ambient temperatures above those indicated on the luminaire nameplate.
- Keep lens tightly closed when in operation.
For supply connections use wire rated for at least 90˚C
FOR MORE LIGHTING INFO CALL
1460 PARK AVENUE, EMERYVILLE, CA 94608
510.891.1056
SOLTECHLIGHTING.COM
2. Installation
