Usage
1. Rework for a variety of components such as: SOIC, CHIP, QFP, PLCC, BGA, etc.
(Especially for phone cable and welding cable split seat)
2. For shrink, drying, paint, adhesive removal, thawing, warm, and plastic welding.
Operating Instructions
1. Put the air gun on the air gun stand.
2. Connect the power
3. Equipment required nozzle( try to using bigger nozzle).
4. When turn on SR-073 enters working mode, LED shows “---”, rework station is standby.
5. Rotate the temperature control knob to set the working temperature.
6. Picked up the handle, the station will enter normal heat welding working station.
Air volume adjustment knob to the right airflow, after waiting for temperature stability
it can normal operation.
7. SR-073 work is completed, the handle must be placed on the holder. And then the
station will cut off the hot air automatically to send cold air cooling heating mode. When
the temperature less than 100, LED display “---” that machine will enter standby mode.
8. Long termed not used must be cut off the power.
Note:
If it possible make use of low temperature and large air volume, that good for save
heating element of the life and safety disoldering IC chip.
Set up the Temperature and Airflow
1. LED digital display microcomputer-based hot air reowrk station:
* In the energized, rotating the temperature control knob temperature. The LED will
display set temperature. After two seconds, real-time temperature display shows
“---” into standby(The handle should be on the holder).
2. After set up the temperature, adjust the air flow to the right to work.
Explanation of symbols
1. Shows “---” mean the air temperature less 100
℃
, the station enter standby and the gun
should be on the holder.
2. Shows “ S-E ” mean the station sensor have problem should be replaced the heater
(Heating material and sensor components).
3. When working, the display temperature less than 50
℃
, and no longer to heat up, that the
heater may be damaged and need to replace the heating element(heating material and
sensor components).
Terms of Use
1. Hot air rework station and surrounding the outlet may have a very high temperature, should be
careful to guard against burns.
2. Heating, the handle must be on the holder, not be placed on work surfaces or other places.
3. Please keep the air gun not have obstructions.
4. After work, must turn off the power, SR-073 gun handle must be placed on the holder, the
machine automatically cooled to below 70
℃
(into standby), and then turn off the power swtich.
5. When using outlet should be kept the distance with the goods at least 2mm, as per outlet to
calculated.
6. As work requirements, choose the appropriate nozzle, different nozzle, different temperature.
OPTION PARTS mm(inch)
“The size in Name/Specification indicates the size of IC package.”
