Sollae Systems CSW-H85N, User Manual

Page: 32 / 83

CSW-H85K User Manual Ver. 2.4
- 31 - http://www.ezTCP.com
3.2 AT command
In the AT command mode, you can change some parameters through the serial port.

Requirements
Make sure the connection between your PC and CSW-H85K using RS232 cross cable.
To use this mode, CSW-H85K has to be set to [AT command] mode on ezManager.
Figure 3-3 setting the communication mode to the AT command

Procedures
Figure 3-4 configuration procedures with AT commands

Available settings
Items Available parameters
IP Address Local IP Address, DHCP, Subnet Mask, Gateway IP Address and etc.
TCP connection Local Port, Peer Address (IP Address or Host name), and etc.
WLAN Topology, SSID, WEP, WPA-PSK, WPA2-PSK and etc.
Option ESC code sending option, timeout and etc.
Table 3-1 available settings by AT command