The RNP255 handheld cordless saw uses a high quality, new generation
carbon-free
motor for propulsion, which has a significantly
longer service life than the carbon motors used previously. Please read the following instructions carefully and follow them to ensure
that the product serves you safely and to your full satisfaction. Avoid unprofessional handling of this tool, and always observe the
electrical appliance use policy. Keep the instruction manual carefully. Never expose to environments with high humidity, avoid contact
of the product with liquids.
TECHNICAL PARAMETERS
Model
RNP255
Operating voltage
21V
Chain speed
5 m/s | 1800rpm
Length of guide rail
10'' | 25.5 cm
Number of accumulators
1
Engine
Carbonless engine
Battery type
Li-Ion battery
SAFETY MEASURES
Wear appropriate clothing, work gloves and eye protection when using this equipment. Before each use, make sure the
equipment is working properly by running it briefly "on empty".
USING
•
When the saw is put into operation, make sure to keep your hands at least 15 cm away from the cutting area.
•
Do not use this saw to cut large branches or it may jam or destroy the motor.
•
When cutting, always keep the object to be cut firmly attached to prevent the saw from "jumping".
•
Do not apply pressure to the saw when cutting.
•
Do not use the saw in the rain.
•
Remove the battery when you are not using the saw.
•
If the power of the saw decreases, check the battery charge or recharge it.
•
It is possible to buy batteries with a capacity of (6 Ah), the
Solight RN-B6
battery designation.
•
In case of damage, a replacement chain can be purchased with
Solight RNP255-R
, and a replacement guide bar with
Solight
RNP255-L
.
CLEANING AND MAINTENANCE
•
Remove the battery before performing any service or maintenance.
•
Wear gloves when handling the chain.
•
Clean and oil the chain after each use.
•
After about 10 hours of use, the cover should be disassembled and the saw cleaned of dust and dirt.
•
Store in a dry and clean environment at room temperature.
•
In case of damage to non-replaceable parts (motor, switch, plastic parts) contact the service centre of Solight holding s.r.o.
•
More complex repairs may only be carried out by experts at the Solight holding s.r.o. service centre.
COMMISSIONING
Fully charge the battery before first use. Then connect it to the saw.
ASSEMBLY OF THE CHAIN
Remove the battery before any service work.
1.
Loosen the locking screw and remove the side cover.
2.
Then remove the guide rail.
3.
First put the chain on the sprocket and then put the chain on the guide rail.
•
The teeth of the chain must point in the right direction!
•
The saw is equipped with a function for adjusting the chain tension. When installing the guide bar, the adjusting element
must be clamped in the positioning hole at the end of the guide bar!
EN
RNP255
Cordless hand saw
Part of the package
1pc hand-held cordless chainsaw
1pc 21V 4Ah Li-Ion battery
1pc charger
1pc instructions
1pc key
1pc screwdriver