4.7 Streaming
UX24 gives two independent
outcoming audio
streams
, and can receive one incoming streaming.
The options for outcoming streaming are:
1.
A streaming
RTP
for point to point link.
2.
A streaming
for upload to servers type
ice-
cast/shoutcast
4.7.1 Streaming signal and send level
Streaming takes the program signal from the AES-1
PGM output, both for uploading to Icecast / Shout-
cast servers and for RTP.
If the gain of the AES-1 PGM output is changed, the
send level for streaming is changed.
4.7.2 Connection and settings
The connection to the LAN for streaming transmis-
sion and reception is done through the
ETHERNET
Streaming Out
connector.
WARNING
DO NOT CONFUSE THE ETHERNET CONNECTOR (CON-
TROL) WITH THE ETHERNET PORT FOR STREAMING.
1.
Connect “Streaming Out” to the LAN router.
2.
The router will assign an IP address to the UX24
streaming device (DHCP). The IP address
shows at the main screen.
3.
The configuration of the streaming services can
be done from the console screens, or using a
network terminal and a WEB browser accessing
the Stream IP address.
4.7.3 UP-STREAM
(TX)
This option is accessed from the console by press-
ing SETTINGS on the main screen. SETTINGS ->
STREAMING has four tabs to configure the different
features. The UP-STREAM tab presents configura-
tion options for uploading to Icecast or Showtcast
broadcast servers.
4.7.3.1 ICECAST/SHOUTCAST STREAM
ENABLE/DISABLED:
Enables the streaming send
for
Icecast/Shoutcast
.
PROTOCOL:
Define if the server is Icecast or Shout-
cast.
SERVER IP:
IP address to which the streaming is
sent. Is the address of I
cecast/Shout-
cast server
.
PORT:
TCP listening port for the server.
MOUNTPOINT:
A unique name that identify
the
stream
at the
Icecast/
Shoutcast server
.
CODEC:
Audio format for the transmission. The
current version of firmware only sup-
ports MP3 coding.
PASSWORD:
Password to access the server (if
needed)
QUALITY:
Audio bitrate.
APPLY:
Name that identify the stream.
NOTE
Settings for
Icecast/shoutcast usually are given by the
streaming provider
.
4.7.4 RTP STREAM
The RTP LINK tab presents configuration options to
send streaming to a specific IP address. It is used to
create point-to-point links, for example, to send the
program signal to the transmission plant (STL).
www.SolidynePro.com
Solidyne UNIDEX UX24
Page 25
