REMEMBER
SAVE THE CURRENT SCENE
TO STORE THE SETTINGS
AND CONFIGURATIONS..
To download a
Quick Installation Guide
(pdf) for
this UDX adapter, go to
Section 7 – Diagrams and
tech notes.
3.4 UDX TEL+BT
The adapter UDX TEL+BT manages one standard
phone line (POTS) and a
Bluetooth link
to pair a
smartphone.
The connection and settings for the POTS lines was
detailed above.
The procedure to pair a cell phone is explained at
section
4.7 – TELCO
.
To download a
Quick Installation Guide
(pdf) for
this UDX adapter, go to
Section 6 – Diagrams and
tech notes.
3.5 StudioBox HD3 & HD5:
monitoring at the Studio
The modules for monitoring
Solidyne StudioBox
HD5 and HD3
resolve the sending of all monitoring
signals to the studio.
3.5.1 CONNECTING
The HD3/HD5 accessories are connected to the
“Monitor Studio”
connector (UX24 rear panel), us-
ing a shielded multipair CAT-5 cable, with connec-
tion over RJ45 T568B (a 5 meter cable is included
with the StudioBox). Through this cable the con-
sole sends the signals to the headphones and
speakers; and receive the Talkback from Studio.
The
speaker output
uses stereo 1/8” TRS connector
(minijack). This is a line level output, intended for
use with powered speakers
.
The
aux input
is used to connect an alternative sig-
nal to the main assigned from the console (ON-AIR,
PGM, AUD, SEND or CUE). The headphones can be
switched between inputs A (console) and B (aux).
•
On HD5 models, A/B switching is available in-
dependently for headphones 1, 2 and 3. Head-
phones 4 and 5 always receive the main “Stu-
dio Monitor” signal, assigned from the console.
•
On HD3 models, headphones 2 and 3 share the
assignment.
The auxiliary input is unbalanced, with RJ45 connec-
tor. The connection to any RJ45 audio output of the
console, balanced or unbalanced, is made using a
standard STP RJ45 cable on both ends (SOL-P25 or
SOL-P50 cables).
Headphone outputs
use stereo ¼ ”TRS connectors
(jacks). Headphones of any impedance can be con-
nected interchangeably (64, 32, 16 Ohms).
NOTE
For HD3, the headphones outputs 2 and 3 are twin: they
shares the level knob and the source assignment.
The UX24 console
supports up to three HD3 or two
HD5
units, which are connected on the “Studio Mon-
itor” output in parallel. RJ45 type “Y” (“Y” splitter)
junction boxes with pin-to-pin connection are used
for the connection.
www.SolidynePro.com
Solidyne UNIDEX UX24
Page 19
To STUDIO MONITOR
UX24 connector
To monitor speakers
Auxiliary audio input
