SolidRun ClearFog PRO, User Manual

Page: 9 / 22

U
SER
M
ANUAL
M
ARCH
2017
SolidRun Ltd www.solid-run.com Page 9 of 22
7 HaMada Street, Yokne’am Illit, Israel
5 I
NSTALLATION AND
S
WITCHING
O
N
This chapter explains the SolidRun ClearFog Pro packaging, how to prepare it for initial use and in what
manner to power it on in its default state. Please note that this section references the diagrams in chapter
2.
5.1 U
NPACKING YOUR
S
OLID
R
UN
C
LEAR
F
OG
P
RO
The package contains:

ClearFog Pro Board

A388 SOM

Heat Sink

Power adapter - 110V/220V US or EU plug (optional)

Blank SD card, 8GB (optional) / eMMC (optional)

Aluminum Enclosure (optional)

User Manual
5.2 P
OWER
A suitable external power supply must be connected to the DC power socket, which has the
dimensions 5.5mm x 2.1 mm cylindrical barrel connector The power supply must be in the range of 9-
32VDC. Recommended values are: 12VDC/2.5A
Please note that the DC jack must have positive polarity in the center pin:
Figure 4 DC Barrel Socket Polarity
5.3 SD
CARD WITH OPERATING SYSTEM AND BOOT SELECT
You will need to download an operating system for the ClearFog Pro and flash in to a blank SD card in
order to use the system. You can download official release distributions and find flashing instructions
at
https://www.solid-run.com/downloads/ . In addition there are also several community released
distributions available. Once downloaded and flashed, the SD card with the flashed OS image must be
inserted into the MicroSD slot on the ClearFog Pro. Before powering up the board for the first time it
is recommended to select the boot media. In order to configure the boot media to MicroSD, please set
the S1 switch to match the second option from the following graphic (SD/eMMC):