Solidator 2.0, User Manual

Page: 12 / 20

12
Your first real print
IMPORANT: Please use safety glasses and nitrile gloves when working with resin and cleaning the objects!
1. Remove the red cover.
2.
Remove the resin container and put it on a table. To see if the sealing is still OK after
transport, pour 1.5 liter water into it. Wait for 15 minutes then pour out the water and make
the resin container dry with a soft paper towel.
Note that there is a film above the glass on the floor of the resin container. There should be
no water below the film. If there is water between the glass plate and the film please contact
support.
3.
Put the resin container in the Solidator with the Solidator logo at the front left.
The metal container has two partial length lines etched on the back wall, the bottom
line is the minimum fill line and the line approx 8mm above is the maximum fill line.
Pour resin into the container until the resin reaches the maximum fill line.
4. Close the red cover with the magnet on the right side.
Magnetic sensor
Cover magnet