Solidator 1.0, User Manual

Page: 10 / 19

10
Resin Container Mounting and Airflow Check
You should wait until the resin container is acclimated to room temperature, when cold it is
possible for the container to deform.
I
nstall the resin container aligning with the full length clamps, tighten the clamps to ensure that
there is no vertical movement of the container.
Next you should check if the there is an air pocket of about 1mm everywhere between the glass
plate and the film of the container. This air pocket is crucial for the machine to work fine.
If you notice an irregular air pocket or if there is any moisture between the glass plate and
the film, using a clean cloth apply gentle pressure to the right side of the resin container
where the two air-exit holes are located. Gently tap the film on the left side of the resin
container until the film is no longer in contact with the glass. Contact customer support, if
problem persists.
Dry Printing
1. Go back to the Main Menu and select Print → select the “calibration block”. Then confirm all
checkboxes (although no resin in the resin container) and press Start.
2. Do not be afraid the motor will go slower and be really loud when going down below the resin
container top edge. This is normal. The motor will stop once the printing plate is at the floor of
the resin container. The slow speed avoids bubble formation but results in louder operation.
3. Let it print for a few layers, then pause and abort the print.