D
De
ev
viic
ce
e
C
Ch
ha
aiin
ns
s
A Chain allows you to insert up to six outboard processing units into one channel. The Chain column on the left-hand side of
the
Insert Matrix
tab lists any Chains you have created.
Creating Chains
To create a Chain, press
New
in the
Chain Setup
area at the bottom of the tab (shown below), type in the name of the Chain
in the
New Chain Name
pop-up which appears and press
OK
. The name you have given the Chain will then appear in the
Chain
Name
box in the centre of the
Chain Setup
area:
You can now select what outboard Devices you would like to include in this Chain, using the six boxes labelled
Device 1
to
Device 6
. The processing order goes from left to right. Press one of the boxes and select the Chain’s first Device from the drop-
down list which appears. The Devices fill the left-most available box, regardless of which box you select. To add another Device
to the end of the processing order, select a blank box, and select the Device from the drop-down as you did before. A Device
box can be returned to blank by selecting
None
from the Devices menu, causing any Devices to the right of it to move one box
to the left.
As the Insert Matrix cannot send more than one signal to a Device, any Devices which have already been assigned to a channel,
either on their own or as part of another Chain, will be absent from the drop-down list.
Chapter 4 - Matrix Remote
60
Matrix Owner’s Manual
Summary of Contents for Matrix
