Solid State Logic AWS DELTA 916, Owner'S Manual, Page: 97 / 239

A
UTOMATION
Motors Off Mode: Touch sense can be enabled or disabled.
Show MTC Display: Turn the timecode display on or off.
T
ALKBACK
Talkback switches are: Select the operation of the talkback buttons: Momentary / Latching / Auto
(Play) / Auto (Record).
Listen switch is: Select the operation of the Listen buttons: Latching / Auto (Play) / Auto
(Record).
Red light switch is: Select the operation of the Red Light: Manual / Auto (Play) / Auto (Record).
TB switches disable Listen: This allows the Listen function to be switched off when talkback is activated,
thus avoiding feedback problems.
TB to FB: (Sums / Replaces) When assigning talkback to foldbacks, this option defines
whether talkback sums with or replaces the normal foldback signal.
See Communications for more details of these options
M
ONITOR SECTION
Monitor Gain Display: The calibration of the main monitor Gain pot and display can be set to one
of three industry-standard monitoring modes: Music (Off to 11) / Film (Off
to 95dB) / Gain (Off to 0dB)
Monitor Set CAL level: When in Film mode, adjust the calibrated listening level: 70 - 90 (dB).
See Monitor Level Display and Calibrated listening level for more details of these options
Solo Gain boost: Automatically increases the monitor level when a SOLO or AFL is activated
(Range: 0-10dB).
Isolated channels AFL on solo: Set solo-isolated channels to automatically solo in AFL (ON/OFF).
D
ESK
S
ETUP
Input Cut Enable: If set ON, the channel strip CUT button will cut prefade sends, ie. Aux and
CHOP sends (ON / OFF).
Analogue Meter Scaling: Set the analogue level corresponding to 0dBfs on the console meters. (Range
18, 20, 22, 24 dBu).
DAW
SETUP
DAW setup parameters can be found in section 4 of this manual; see page 4-3 for more details.
D
ESK SETTINGS
Scribble Strip Brightness: Use this to adjust the channel scribble strip brightness (range: 1-6)
Turn Off Display After: Shuts off the TFT display after a predetermined time: 30 mins to 5 hours in
30 minute increments.
The scribble-strip displays can be turned off by turning the control pot clockwise (beyond 8 or 6) to ‘Off’.
On occasion, when changing the status of some of the above functions, you will be prompted to reboot your AWS δ elta
console. It is possible to do this without reaching the Power switch at the rear of the console through the addition of a
soft menu RESTART . When you select this you will be prompted to CONFIRM and your console will reboot.
Analogue Operations
AWS
δ
elta Owner’s Manual Page 3-31