Solid State Logic AWS DELTA 916, Owner'S Manual, Page: 124 / 239

Plug-In Display Modes
There are three display modes, Insert, Parameter and Assign, which are selected with the
ASSIGN
and
INSERT/PARAM
buttons below the V-pots.
V
IEWING
C
URRENT
I
NSERTS
(I
NSERT
M
ODE
)
Press the
INSERT/PARAM
button till the
INSERT/PARAM
box reads
INSERT
; the plug-in editor is in Insert mode.
In this mode the four V-pots represent four insert points on the selected channel. The currently assigned plug-ins are
displayed above each V-pot. The name of the currently active plug-in will flash.
Additional insert points can be displayed using the paging buttons.
The four V-pot push switches can be used to select an insert slot for editing or for plug-in assignment - see below.
A
SSIGNING A
P
LUG
-I
N OR
H
ARDWARE
I/O (I
NSERT
M
ODE
)
Note: Some DAW applications will not allow assignments to be made during playback, or recording.
T
O
A
SSIGN A
P
LUG
-
IN TO A
C
HANNEL
I
NSERT
P
OINT
:
1. Press the
ASSIGN
soft button to enter assign mode; the on-screen box flashes to confirm this.
2. Press the V-pot corresponding to the insert slot which you wish to route to a plug-in (use the paging buttons if
necessary) then use the V-pot to scroll through a list of plug-ins and I/O slots. The names that are displayed are derived
from the DAW.
3. To confirm the assignment either:
a) Press the
ASSIGN
button a second time. This will exit
INSERT
mode and switch the Plug-In Editor
to
PARAMETER
mode for editing of the last selected insert.
b) Press the V-pot used to make the assignment. This will confirm the assignment and leave you in
Assign mode so you can make further assignments.
A
SSIGNING THE
S
AME
P
LUG
-
IN TO
A
LL
C
HANNELS
Follow steps 1 and 2 above to select a plug-in, then hold down the
OPTION
button before pressing the V-pot switch to
assign a plug-in to all channels.
A
SSIGNING
T
HE
S
AME
P
LUG
-
IN TO
S
ELECTED
C
HANNELS
To assign a plug-in to selected channels select
SEL
mode on the Master Control Panel then choose the channels you wish
to assign to by holding down
SHIFT
and pressing the channel
SEL
keys.
Follow steps 1 and 2 above to select a plug-in, then hold down
OPTION
+
SHIFT
before pressing the V-pot switch to
assign the plug-in to the selected channels.
DAW Control
Page 4-20 AWS
δ
elta Owner’s Manual