10
point 1.2).
It is also necessary to replace the hob's solenoid assembly and modify the controller
software. This procedure can only be performed by an authorised service centre.
3.3.
Maintenance and inspections of hob elements
When operated in accordance with this instruction manual, and cleaned
and maintained,
a properly working
hob does not require inspections.
4.
USING THE HOB
4.1. Initial activities
After installing the hob in accordance with point
2.
:
- place the burner body
(item 5, fig. 2)
in the hob's body
(item 7, fig. 2)
paying
attention that it is evenly (horizontally) placed,
- place the burner cap
(item 3, Fig. 2)
centrally on the burner ring; be careful when
placing caps on burners with a temperature sensor
(item 1, Fig. 2)
,
- place grids
(item 2, Fig. 2)
on the hob's glass plate, making sure that the metal pins
fit the openings in the glass,
- insert the plug of the power supply cable into the mains power socket
and place the
12 V low voltage cable
ended with a circular plug
in the power socket of the
hob (it is located on the bottom of the device, in the lower right corner, under the control
panel),
- open the cut-off valve on the gas supply line to the hob,
- once connected to electrical power, the hob will start its calibration mode. The
timer section of the display will show "00" and horizontal signs will appear above the
burners' sensors. Once the markings above the sensor of the upper right burner disappear, a
blinking calibration symbol will appear. When this disappears, the hob enters standby mode
and is ready for use. This is signalled by an indicator light
(item 1, Fig. 6)
. Stepper motors can
be heard during calibration (knocking).
When the hob is used for the first time, open a window and assure air access to the
room. This will ensure better air exchange in the kitchen, allowing unpleasant odours to
escape.