11
Auto Mode
1) Install the exhaust hoses and window kit properly (see pages 7 & 8).
2) Plug the Power Cord into an electrical outlet.
3) Turn on the unit by pressing the
ON/OFF
button on the control panel.
4) Press the
MODE
button until the “AUTO” icon appears on the control panel display. Select the fan speed
by pressing the
FAN
button.
NOTE:
During AUTO mode, the unit operates in
Dehumidifier
mode when the room temperature is between
68
°
F to 80
°
F. And
Air Conditioner
mode when the room temperature is above 80
°
F.
Emergency Condensate Holding Tank
When the unit is in cooling mode, unwanted water is extracted from the air. Most of this water is used to cool the unit
and make it run more efficiently. When the unit is used in extremely humid environments, water will collect in a water
container at the bottom of the unit. When the water container is full, the compressor will stop but the fan will continue to
run.
1.
Turn the unit off. Do not move the unit when the water container is full.
2.
Place the drain pan accessory under the drainage port at the back of the unit.
3.
Remove the rubber plug from the drain hole. The condensate water will drain out automatically. When the drain pan
is full, replace the rubber plug into the drainage hole to stop the water flow. Empty the drain pan. Repeat until all the
water is emptied.
4.
If the unit is placed close to a drain, you may attach the drain hose and drain the water into the drain or pan.
Once the water container has been emptied, replace the rubber plug into the drain hole firmly. Do not
allow the water to drip continuously into the drain pan, as it might easily overflow.
