9
#98
. M6 x 15mm
Phillips Head Screw (4 pcs)
#99
. M5 x 12mm
Phillips Head Screw (8 pcs)
#105
. 4 x 16mm
Sheet Metal Screw (4 pcs)
1.
Install the Seat (
61
) on the Seat Carriage (
4
) with four Phillips Head Screws (
98
) using the
Phillips Head Screw Driver (
114
).
2.
Install the Front Stabilizer Cover (
32
) and the Rear Stabilizer Cover (
37
) on the Main
Frame (
1
) with four Phillips Head Screws (
99
) using the Phillips Head Screw Driver (
114
).
3.
Insert the Computer Cable (
44
) and Hand Pulse Cable (
45
) into the connector in the back
of the Console Assembly (
19
). Install the console onto the mount- ing plate with four
Phillips Head Screws (
99
) using the Phillips Head Screw Driver(
114
). Be careful not to
pinch the cables between the console and the mounting plate. This could short the cables
and damage the electronics.
4.
Install the Drink Bottle Holders (
39
L,
38
R) onto left and right sides of the Seat Handle Bar
(
6
) with four Sheet Metal Screws (
105
) using the Phillips Head Screw Driver(114).
5.
Install the Pedals (
116
L,
117
R) onto the Cranks by using the 14/15mm Wrench (
132
).
Remember that the Pedal (
116
L) has a reverse thread and will be screwed into the crank
in the opposite rotation from normal threads.
There is an “L” stamped into the end of the threaded post of the left pedal and an “R” in the
right. Make sure to fasten the pedals as tightly as you can.
6.
It may be necessary to re-tighten the pedals if you feel a thump while pedaling the bike. A
clicking or thumping noise while pedaling is usually caused by the pedals being too loose.
4
SEAT/PEDAL &
PLASTIC PARTS
HARDWARE
STEP
4