Sole Diesel 100 GTA, Operator'S Manual, Page: 40 / 76

TROUBLESHOOTING
40
Manual del Operador Grupos Electrógenos Marinos
Revisión 2. 10/2017
GENSET FAILURE PROBABLE CAUSES RECOMMENDED ACTIONS SECTION
Fuel injectors dirty or faulty
Clean, test and/or replace the inoperative fuel
injector.
6.5
Fuel injection timing out of adjustment Adjust the fuel injection timing. 6.5
Fuel tank empty or fuel valve shut off
Add fuel and move the fuel valve to opened
position.
6.5
INLET AND EXHAUST
SYSTEM
Air filter clogged Replace air filter element. 6.7
STARTS THEN STOPS
GENERAL Governor inoperative Contact with our dealer -
FUEL SYSTEM
Fuel pump faulty or clogged Check inlet of fuel pump. 6.5
Fuel filter clogged Replace fuel filter. 6.5
Air in fuel system Bleed fuel system. 6.5
Injection pump incorrectly set Contact with our dealer -
Fuel outlet cock closed Open fuel outlet cock. 6.5
COOLING SYSTEM Coolant level low Restore the coolant to normal operating level. 6.6
PANEL SVT Key switch
Check the pin connections. Above all, the pins
that give signal to stop solenoid and fuel pump.
-
NO OR LOW OUTPUT
VOLTAGE
GENERAL
Engine overload Reduce the electrical load. -
Governor inoperative Contact with our dealer -
ALTERNATOR (AC)
AC output circuit breaker open Close AC circuit breaker. 5.9
Wiring, terminals or pin in the exciter field
open
Check for continuity. 5.9
Main field (rotor) inoperative (open or
grounded)
Test and/or replace the rotor. 5.9