Subject to change | © 2020 SOLARWATT GmbH | AZ-TM-PME-1787 | Rev 000 | Version: 03/2020
Page 32
Troubleshooting
The MyReserve’s Status LED will light up red or red/yellow
to indicate any malfunctions. Under certain circumstances
(and after consulting with your installer), some error codes
can be resolved by simply restarting the system manually.
To do this, interrupt the power supply to the MyReserve
using the switch on the bottom of the MyReserve Com-
mand (see figure under „Components and construction“:
AC power supply switch) wait 60 seconds, then switch the
AC power on again.
Critical states
If any of the following critical situations develop, open a window, immediately leave the installation location, close the door,
and then call the emergency services.
Warning of fire-
explosive substances
Warning of danger
from batteries
Warning of potentially
explosive substances
•
Electrolyte leaking out
•
Strong, pungent smell
•
Development of smoke
•
Storage battery burning
Immediately leave the installation location and then call
the emergency services
UK: 999/112
AUS: 000
NOTE
After a restart of MyReserve, an initialization with calibration and check of the start conditions takes place (a
PV-surplus must be measured once).
Unloading will not occur until the following day after MyReserve has detected a minimum surplus of PV energy.
DANGER
Defective batteries can result in harmful or even fatal hazards.
Should you discover one or more defective battery modules leaking electrol-
yte and/or emitting an unpleasant smell, contact SOLARWATT immediately.
Do not approach the battery modules under any circumstances.
Defective batteries can cause explosions. They represent a danger to life
and limb.
