Page
1
of
2
SolarGoesGreen SGG-FL12W-Extreme
READ AND FOLLOW ALL INSTRUCTIONS BEFORE OPERATING YOUR SOLAR LIGHT.
SAVE THIS MANUAL FOR FUTURE REFERENCE.
DESCRIPTION
The SolarGoesGreen solar SMD-LED flood light is the premier choice for indoor or outdoor solar lighting. The versatility of
the SolarGoesGreen SGG-FL12W-Extreme makes it the best choice for use in gardens, parks, warehouses, garages, driveways,
signs, yards, farms, horse riding arenas and businesses. The SolarGoesGreen solar LED security flood light is easily installed.
The battery is protected by an auto-detection circuit maximizing the brightness of the lamp and allowing the light to operate
longer as the battery charge declines.
PARTS
2 each 20W hinged Solar Panel
1 each 30 SMD-LED Light with 11.1V Lithium Ion battery
1 each RF Wireless Remote Control
1 each external PIR motion sensor
1 each Allen wrench
1 each Ground Stake for Solar Panel
2 each Wall Mount for Solar Panel
2 each Flat Bar Stock
Mounting Screws
INSTALLATION
1) INSTALLATION OF SOLAR PANEL
a) GROUND STAKE*
For optimum performance, the solar panel must be facing the southern horizon and positioned at a 45 degree angle
using the ground mount stake provided.
b) WALL MOUNT*
Using the flat bar stock provided, lay the solar panels on a flat surface and straighten
hinged solar panel by screws provided
Note pre-drilled 3 holes on each short side of solar panel
Observe there are also 3 holes on side of wall mount hardware.
Push wall mount to flush with edge of solar panel outside edge as illustrated by images.
Use 3 screws (provided in hardware pack) and attach wall mount to solar panel
Place solar panel onto wall or flat surface and mark eight mounting holes through the
wall mount onto wall or flat surface.
Drill holes into wall or flat surface as marked above.
Remove wall mounts from solar panel for next easy installation.
Place wall mount bracket on wall or flat surface and attach with screws provided in
hardware pack.
Reattach the solar panel on the installed wall mounts.
2) INSTALLATION OF LIGHT
Mount the light to customer supplied pole or attach it on the wall using mounting screws provided.
Connect lamp wire to solar panel connector.
Located on the lamp housing, switch the power button to the ON position. Lamp will light up (flash on then off) and shut
down after several seconds.
Please note the lamp is off when the Power button switch is sunken and the lamp is ON when
the button switch is in the popped up position.
To test operation of unit, completely shield the face of solar panel by laying it face down on a flat surface or cover the panel
with thick black cloth. The lamp will turn ON after several seconds.
After completing the above, the remote control functionality can now be used to manage the unit’s brightness and working
time independently. Please note
the remote control only operates light function when the switch is set to the "ON" power
position on light.
