6 Hydraulic connection
Heating circuit connection on the condenser
Fig. 2-27_015AT
1 Heating circuit flow outlet
2 Heating circuit return inlet
Cut insulating mat (only required for K 08 and K
10)
►
To introduce the heating circuit lines, cut the
soundproofing insulation (mat). After installation
of the pipes, pay attention to the best possible
sealing.
Fig. 2-28_006BN Cut insulation mat
6.5.1 Connection set vamp
air
The two SOLARFOCUS connection sets are fitted at
the factory for direct connection to the condenser
(plate heat exchanger).
i
When using the optional electric heating
element, the flow line on both connection sets
must be shortened on site (the flow connection
is located lower in the case of the electric
immersion heater than in the plate heat exchan-
ger).
Bottom connection set
–
Connection with the heat pump pipe inserted from
the bottom
–
Item no. 25105
Vent valve
1
Fig. 2-29
Fig. 2-30: Components of bottom connection set
18
Installation manual
vampair
