15 Weatherman function
15 Weatherman function
Function: The control eco
manager-
touch
receives cur-
rent weather forecast data on an ongoing basis. If good
weather is forecast, then the control delays starting
the burner when there is a heating request.
The requirements for using the weatherman function
are as follows:
–
The software version of the control is ≥ V 15.090;
for thermi
nator
II touch.
–
Registration of the heating boiler on the web server
SOLARFOCUS, or in the
mySOLARFOCUS app
,
.
After successful online registration of the heating sys-
tem, after approx. 2 to 3 hours, the 'weatherman' but-
ton
1
is displayed in the
Selection menu
.
Fig. 2-49_01-132-01
Press the button
1
to access the weatherman menu.
If you cannot see the button, check the following (see
mySOLARFOCUS app
,
).
n
Has your heating system been correctly registered
on the SOLARFOCUS web server?
n
Is the connection status between the control and
the SOLARFOCUS web server
online
?
n
Is the
Send data parameter
set to
Yes
?
15.1 Information
The
weatherman information
menu visualises the cur-
rent weather forecast.
Fig. 2-50_01_121
Weatherman function
1
Off
: The weather forecast is shown in the display, but
does not influence the control at all.
On
: The weather forecast influences the behaviour of
the control in the menus
–
Heating circuit
–
DHW heating
–
Buffer tank
The following applies for three menus: The level of
influence can be set using the plus/minus buttons on
the bars, in 10 % steps,
–
0% means that good weather being forecast has
no influence on the control of the heating cir-
cuit/drinking water/buffer tank charging.
–
100% means a maximum level of influence.
15.2 Heating circuit
This menu
1
is only visible when a heating circuit in the
boiler control is enabled.
Fig. 2-51_01_122
Operation manual
therminator II touch
33
