SOLARFOCUS octoplus, Installation Manual

Page: 19 / 48

Installation
Installation manual octo
plus
19
Fig. 5-12
Prepare downpipe insert
Bend the finger of the downpipe
insert
1 to an angle of ~80°.

Tip: use pliers.
Fig. 5-13
Install downpipe insert and pipe
clamp
Position pipe clamp 1 including
downpipe insert 2 to the down-
pipe bracket.
Check 3 : The finger of the down-
pipe insert must be aligned (in
plan view) to the boiler back
panel.
Fig. 5-14
Installing the pellet feeder unit
Slide the pellet feeder unit 1 into
the intermediate pellet store.
Connect the two connection spig-
ots with the pipe clamp
2 .
Attention! Open filling chamber
door 3 and reach into the downpipe
from below:

Check for correct
seat / orientation of the downpipe
insert.
Check horizontal / vertical orien-
tation of the intermediate pellet
store, readjust if necessary.
Tighten up screws on the inter-
mediate pellet store console
4 .