Chapter 7: Setting Up Communication
Safety and Monitoring Interface Installation Manual – MAN-01-00067-2.1
35
35
Creating an Ethernet (LAN) Connection
Overview
This communication option enables using an Ethernet connection to connect the SMI through a LAN
network to the monitoring portal.
Figure 16: Example of Ethernet Connection
Ethernet Communication Configuration Options
The following is a description of the options to configure the Ethernet (LAN) port settings.
Communication
S e r v e r < L A N >
L A N C o n f
R S 4 8 5 - 1 C o n f < S >
R S 4 8 5 – 2 C o n f < >
Z i g B e e C o n f < >
R S 2 3 2 C o n f
LAN Conf
I P C o n f i g
S e t D H C P < e n >
S e t I P
S e t M a s k
S e t G a t e w a y
S e t D N S
S e t S e r v e r A d d r
S e t S e r v e r P o r t
IP Config:
Displays the current IP configuration of the SMI, as shown below. If DHCP is used, this
screen reflects the parameters retrieved from the DHCP server. If manual settings are used, the
screen shows the last manually input configurations.
I P 0 . 0 . 0 . 0
M S K 2 5 5 . 2 5 5 . 2 5 5 . 0
G W 1 9 2 . 1 6 8 . 0 . 1
D N S 0 . 0 . 0 . 0