Verifying the Meter Connection
Verifying the Meter Connection using SetApp
To verify the meter connection using SetApp:
1. From the SetApp main menu, select Status.
2. On the Status page, scroll down to the
Communication
status section. Check that one or more meters is connected
to the RS485-1 or RS485-2 bus.
Communication
LAN
Connected
RS485-1
Modbus
2 of 2
RS485-2
SE Slave
None
Cellular
N/A
Wi-Fi
NC
ZigBee
NC
3. Continue scrolling to the
Meters
section. If there is more
than one meter/function, there is a status sub-section for
each one. An example appears below. The following
information is displayed:
Energy Meter with Modbus Connection Installation Guide MAN-01-00269-1.5
Chapter 3: Configuration
39