Set Server Addr
: Set the IP address of the SolarEdge monitoring platform. This
option is predefined in the SolarEdge Firefighter Gatewayto specify the SolarEdge
monitoring platform IP address and does not normally need configuration.
Set Server Port
: Set the port through which to connect to the SolarEdge monitoring
platform. This option is predefined in the Firefighter Gateway to specify the
SolarEdge monitoring platform IP port and normally does not need configuration.
NOTE
If your LAN has a firewall, you must verify that the address and port
configured in the
Set Server
Addr
and the
Set Server Port
fields are
not blocked. You may need to configure it to enable the connection
to the following address:
Destination Address: prod.solaredge.com
Port: 22222
Connecting and Configuring LAN
To connect the Ethernet cable to the router/switch:
1. Use a pre-crimped cable or use a crimper to prepare an RJ45 communication
connector on both ends of a standard CAT5/6 cable: Insert the eight wires into the
RJ45 connector.
CAT5/6 standard cables have eight wires (four twisted pairs), as shown in the
diagram below. Wire colors may differ from one cable to another. You can use either
wiring standard, as long as both sides of the cable have the same pin-out and color-
coding.
RJ45 Pin #
Wire Color
10Base-T Signal
100Base-TX Signal
T568B
T568A
1
White/Orange
White/Green
T
2
Orange
Green
Transmit-
3
White/Green
White/Orange
4
Blue
Blue
Reserved
5
White/Blue
White/Blue
Reserved
6
Green
Orange
Received-
7
White/Brown
White/Brown
Reserved
8
Brown
Brown
Reserved
Chapter 6: Setting Up Monitoring through the Firefighter Gateway (Optional)
46
Firefighter Gateway Installation Guide MAN-01-00113-1.4