I P C o n f i g
S e t D H C P < e n >
S e t I P
S e t M a s k
S e t G a t e w a y
S e t D N S
S e t S e r v e r A d d r
S e t S e r v e r P o r t
M o d b u s T C P < D i s >
IP Config
: Displays the current IP configuration of the Firefighter Gateway, as
shown below. If DHCP is used, this screen reflects the parameters retrieved from the
DHCP server. If manual settings are used, the screen shows the last manually input
configurations.
I P 0 . 0 . 0 . 0
M S K 2 5 5 . 2 5 5 . 2 5 5 . 0
G W 1 9 2 . 1 6 8 . 0 . 1
D N S 0 . 0 . 0 . 0
Set DHCP <En>: If the LAN connection between the Firefighter Gatewayand the
SolarEdge Monitoring Platform has a DHCP server, enable this option by setting it
to Enable (default). If this option is enabled, then the DHCP server automatically
configures the IP, Subnet Mask, default gateway and DNS. If not, set them
manually.
Set IP
: Enables setting the IP of the default gateway according to the LAN settings:
Use the
Up
and
Down
buttons to adjust the value of each IP address octet.
Press the
Enter
button to move to the next IP address octet.
Long press the
Enter
button (until
Applied
message appears) – apply the value
Long press the
Esc
button (until
Aborted
message appears) – erase all characters
S e t u p I P
1 9 2 . 1 6 8 . 2 . 7
Set Mask
: Set the subnet mask of the SolarEdge Firefighter Gateway according to
the LAN settings.
Set Gateway
: Set the default gateway address of the SolarEdge Firefighter
Gatewayaccording to the LAN settings.
Set DNS
: Set the DNS of the SolarEdge Firefighter Gateway according to the LAN
settings.
Firefighter Gateway Installation Guide MAN-01-00113-1.4
45
Creating an Ethernet (LAN) Connection
LAN Conf: